TEL: 02155422791
لوگوی سیم بکسل تکین بکسل

Green pin Turnbuckle

The Turnbuckles should only be used for direct or indirect pulling. You need to pay special attention to avoid overload. When pulling, the forces on the turnbuckle must not be such as to cause deformation. In the event of deformation, the tension must be reduced immediately and the deformed parts replaced. In case of using the correct conditions or shock loading, if selected, should be considered. Pinb green screws are used for forging wires, ropes, rods, etc. The load limit (WLL) should only be applied in a straight line and no overload is allowed.

Green pin Turnbuckle
تکین بکسل

TEL : 02155422791
Email: info [at] takinboxel [dot] ir
طراحی و سئو توسط:
نانوتجارت

© Copy right 2023 | All ights Reserved | takinboxel Corporation